Software updates skyview
- 16 July 2015
- News / Eventi
- Posted by Super
- Leave your thoughts
Here’s how to upgrade to system software skyview: – for aircraft with engine 914 turbo we recommend you turn off these utilities before proceeding with the operation: pump 1, pompa2, TCU and avionics as radio, transponder, intercom, strobe, landing light. < / p> – for 912 aircraft with engine: recommend turning off: pump 1, avionics such as radios, transponders, intercom, strobe, landing light. Turning off the utilities can ‘be made by removing the brekaer (breaker provided for disarmament) or by switching the switch on users. NOTE: After upgrading restore all breakers of the aircraft. We recommend to attach the battery on board the aircraft to a battery charger / maintenance charger to keep the battery on board you can download too. Verify that all system components are turned on Skyview (primary and secondary monitors, ADAHRS, autopilot servos etc ..) Download the latest firmware (currently 5.1.0): http://dynonavionics.com/downloads/Software/SkyView-5.1.0-dynon_update.dup Download the package improvement for the use of the GPS Map: http://dynonavionics.com/downloads/Software/map_graphics_text_update.dfg (download files with the browser Internet Explorer or Chrome, Safari is not supported) Download the detailed package countries Base map: http://dynonavionics.com/downloads/basemap/base_map_europe_5.dup So, put these three files to a USB stick empty (min. 1 GB) Reduce to 50% brightness of all monitors skyview through: Menu ‘Screen> DIMM> Dimm – If your avionics system has more ‘than a monitor Skyview started to do the update from the monitor placed in front of the pilot location 1) insert the USB stick into the USB port of the monitor (or behind the instrument panel) press 7 + 8 (buttons extreme right), then confirm the first item shown on the monitor: Upgrade to version and proceed …. 2) Leave the key inserted in the monitor until the display does not complete the whole procedure, (about 5 minutes) and back to where PFD shows, MAP and EMS 3) once finished the procedure to remove the USB drive, then put it in the other display and repeat the procedure 4) Make sure that the system recognizes all dipositivi Dynon (actuators and ADAHRS, EMS, transponders etc .. 5) Now you can load the other two files (package improvement and GPS detail countries) reinserting the USB stick in the first monitor 6) press 7 + 8, then select the first item SYSTEM SOFTWARE 7) select LOAD FILE 8) to select and load the two files in both monitors 9), remove the key and the charger from the aircraft. 
< / a>
